105 degree Fuel Fitting Tri-power Engine Compartment We have seen time and

We have seen time and time again the small brass floats for the center carburetor used in the large end carburetors

Mike has been using these composite floats in his restorations when needed

just a few days

If you have a vacuum leak around the throttle shaft you may only need to replace the throttle shaft because it is worn and not the entire throttle body

Pair of steel lines from center carb to intake

105 degree Fuel Fitting Tri-power Engine Compartment We have seen time andUsed for rear carb on the 1964 to 1966 and the center carb in 1966. Some carbs had the 90 degree as cheap substitution. The 105 degree fitting kicks the line out, away from the carb. The 1966 tripower used 2 of the 105 degree fittings center and rear carb. The 1964 and 1965 tripower only use one, on rear carb.