Rear Hub Cap w/ 7 1/2" I.D. Cone Pointed Stainless Steel #20188-EACH Material: chrome plastic

Material: chrome plastic

slide plate over switch and center

align the notches on the hub cap with the locators on the wheel and push into place by gently tapping on the outer edge of the hub cap or use a hub cap mounting tool

Kenworth models W and models T 2006 and newer

2 1/8 ouside diameter

Rear Hub Cap w/ 7 1/2" I.D. Cone Pointed Stainless Steel #20188-EACH Material: chrome plasticMaterial: stainless steel Application: fits rear axle with 7 1 4" diameter with 12 of the 1 2 inch studs Not sure what size you need? Measure the inside diameter your old hub cap and studs or measure the axle and studs to determine the size needed. Mount: remove old hub cap, center the hub cap over the axle and push into place or use a hub cap mounting tool. Sometimes they would not quite over the lug nuts, so you will need to turn some of the lug